Fisher and Paykel DD603 free download

File name 36119610-Fisher-Paykel-DD603-Dishdrawer-Diagnostics.pdf

Fisher-Paykel DD603 Dishdrawer DIAGNOSTICS Dishwasher Diagnostics can only be entered in Power Off mode, ie. when there is no display on the LCD or the badge LED's are off. Diagnostics is entered by holding the KEYLOCK and START/PAUSE buttons simultaneously for 5 seconds. Ensure that KEYLOCK is pushed first. There are currently four levels of diagnostics. To move to the next level push POWER. To enter a level push START/PAUSE. Once a level has been entered, pushing POWER will exit diagnostics completely. If no level is entered, then the display will cycle through the four levels and exit after the last. On entering diagnostic mode, the first level is the Display/Download Mode. DishDrawer Diagnostics Display/Download Mode In this mode, all LED's and LCD segments (except keylock) are illuminated. Optical LED Download/Fault Display An optical data download is available here to download all EE data to a PC or Palm PC via the lower tub-home sensor light pipe. Hold the reader pen over the lower tub-home sensor light pipe and press START/PAUSE to initiate the download. A short beep indicates the start and finish of download. The last two faults are displayed on the LCD (secondary control panel LEDs for integrated models) during the optical download. The Current Fault code is displayed first followed by the Previous Fault Code. To read the Fault Code on the secondary display, refer to page 7 on Fault Codes. Clearing Fault Logs To clear the Current Fault, press the KEYLOCK button until a beep is sounded. This action moves the Current Fault into the Previous Fault while clearing the Current Fault. To Clear the Previous Fault press KEYLOCK once more until the beep is sounded. Warning: Once a fault has been cleared, it is permanently removed from memory and cannot be recovered. Press POWER to advance to the next level. For more help, go to Fixitnow.com Samurai Appliance Repair Man 8 Hardware Output Diagnostic Test Mode This level tests all the hardware outputs and inputs. The LCD display shows "HO". Press POWER to skip hardware diagnostics and advance to the next level. Press START/PAUSE to enter hardware diagnostics. Once hardware diagnostics has been entered, the current hardware output being tested is indicated by letters in the LCD display, and for integrated models the LEDs on the touch switch panel using binary encoding, as shown in the table on the next page. Different combinations of outputs can be switched on or off together, but the controller will prevent higher current drawing components such as the wash pump and the lid motors being turned on together. Press START/PAUSE to advance to the next hardware output. Press KEYLOCK to turn the currently displayed output on or off. If the scrubbing brush symbol (green LED above start/pause button on integrated models) is displayed, then that output has been switched on, and if it is not displayed then that output is off. Press POWER to Exit at any time (all outputs will be switched off on exit)